Hello everyone!
This is a thread for a big project of mine, using the few pictures of this throne available i'll be attempting to produce it in 1/6 scale before Hot Toys releases their inevitable 1/6 Thanos figure from the MCU.
I have started with drawing blueprints for the throne based on the picture and screencaps i have and when completed i will be turning them into a 3D model and eventually printing it in pieces and from that producing the final piece.
Comments and critiques appreciated
Thanks for looking!
Front and back done, side and top almost done
This is a thread for a big project of mine, using the few pictures of this throne available i'll be attempting to produce it in 1/6 scale before Hot Toys releases their inevitable 1/6 Thanos figure from the MCU.
I have started with drawing blueprints for the throne based on the picture and screencaps i have and when completed i will be turning them into a 3D model and eventually printing it in pieces and from that producing the final piece.
Comments and critiques appreciated
Thanks for looking!
Front and back done, side and top almost done
Last edited: