megeman volnut full custom 1/6 figure possible 3d printed

[TimespliTT]

I want a figure made from the ground up. I contacted sebs customs and he could do it but at a cost and time and kinda hard, he mentioned that 3d printing could be the way to go. but I don't know who to contact or where to begin. anyone got any leads or knowledge of 3d printing?

I know the 3d printing material isn't as strong and you have to sand paper it, also not sure if it will crack.

 

[SigitoSutasmano]

usually the 3d printed model is used for a casting, so you won't use the master model. if you print it with a good printer you won't have to sand it down because it's in high resolution quality. maybe a bit sanding but not much.