TonyMeis
Super Freak
Does anyone here know how to shrink a 1/6 resin head?
Or does anyone here does it?
Or does anyone here does it?
Put it in the microwave for 60 seconds
Put it in the microwave for 60 seconds
Put it in the microwave for 60 seconds
Sounds like it's the way to make it bigger?
But then again, are u serious? Microwave won't damage the sculpt or make it explode?
Thanks for the help. Found the videos.
Hydrospan 100 to make it bigger:
https://m.youtube.com/#/watch?v=uDry-goiVTY&desktop_uri=/watch?v=uDry-goiVTY&gl=GB
Hydrospan 400 to make it smaller:
https://m.youtube.com/#/watch?v=9YFjtKqv3QE&desktop_uri=/watch?v=9YFjtKqv3QE&gl=GB
Looks awesome.
Still wondering if there is any other way? Not sure if I can get the solutions here in my country.
Any other fool proof method?
I honestly hoping that the microwave method works for expansion, but apparently not
Less expensive way: put about 10 per cent of WhitevSpirit in your Mold mix. When it's dry, make a cast everyday until you have the correct size ( when the white spirit evaporates, little by little it contracts the mold, making the cast slightly smaller every time. In the case of a very large head, you may have to make several molds, using the smaller head you,ve achieved as the mold only contracts up to a certain point)
I believe there is a product out there called reduce it. You will need to make a mold of the larger head and use the reduce it in that mold. The head will reduce in size after molded.
Here you see head I schrunk using Hydrospan 400
You see that is Slowly shrinks. Both smaller heads were cast from the same big molds a day or so apart :
Enter your email address to join: