I’ve always wanted a Han in carbonate to display with my boba but have been too cheap to buy sideshows, so when my friend was gifted a 3D printer and was learning how to use it, I asked if he wanted to learn by printing me a Han lol
I found a not super accurate but decent looking file on thingyverse and sent it to him.
Unfortunately the first one ran out of filament about 80% through the print so it was in two pieces
After rounds of glueing, filling, priming, sanding, priming, and sanding I think it turned out ok
Obviously it’s not perfect, I’m no artist, and by no means is it the sideshow piece, but I’m pretty happy with my lil weekend project.
I still need to get the Volvo panels for the sides printed and glued
He did however print me another one so this was just the test run
I found a not super accurate but decent looking file on thingyverse and sent it to him.
Unfortunately the first one ran out of filament about 80% through the print so it was in two pieces
After rounds of glueing, filling, priming, sanding, priming, and sanding I think it turned out ok
Obviously it’s not perfect, I’m no artist, and by no means is it the sideshow piece, but I’m pretty happy with my lil weekend project.
I still need to get the Volvo panels for the sides printed and glued
He did however print me another one so this was just the test run
Last edited:
