1/6 The Batman ‘the drifter’ discussion thread

[DiostaR]

Ok so I might have a solution for a DIY adaptator.

You just take one like these and cut the "ring" part of the peg (in red on the picture) and the little molding left over on the top of it.
Then you could use a dremel to dig a hole and glue a magnet in or just use some electrical tape to add a few layer of thickness to the peg so it hold the headsculpt nice and tight.

I suggest to add a layer of electician tape over the magnet too if you go that route to make sure you have an extra protection so the magnet doesn't unglue and get stuck in the neck of the headsculpt.

 

[DiostaR]

Here's the result. It's not as powerful as the original one but it works.
To make sure it nice and secure you could add another later of tape.

 

[r0cket147]

They ended up saying you'd have to get it separately. But yeah we'll see hoping they make one.

There is hope:

that’s the post:

 

[Hologram AI]

There is hope:

View attachment 699473


that’s the post:

Nice. Happy to see them giving this a lot of attention. This is gonna pair really nicely with the rooted racoon sculpt.