GFF Metal Composite is replacement of the gundam fix figuration.
Or SUper HCM line "may not have metal".
Instead of soft revoltech material. You have that high quality metal and plastic.
1/144 GFF Metal Composite Psycho Gundam
They are also in scale to gundam 1/144 model kits. instead of...
PG Freedom Gundam 1/60
MG Exia was a very good model kit built to look great. I really though the MG Hi nu had a good frame but wasn't the best. Well I think the raisers form is more high tech so pistons and mechanical details were lesser due to the slim design. They could of done better on...
A Master Grade inner frame = PG Raiser 00 1/60
A Perfect Grade inner frame = PG GP-01 FB or Ground Type
Lesser Part Counts is a MG inner frame.
What I mean was the PG Raiser feels like a MG inner frame and not a PG Inner frame.
Perfect grade 00 is definitely not worth the price.
25000yen
Its a big size Master grade model. "Added -> MG inner frame style with air packets in a big box"
delete -> No inner frame and the box is big with air pockets everywhere.
-> A better buy below.
1/60 Perfect Grade RX-78 Gundam...
If you need help in fixing the pin . Goto www.hobbyfanatics.com and go to the mecha section. theres alot of people that work on resin kits and they will tell you the proper way to pin that arm back.
Easy fix . The pin in the tube of the hand uses 2 stick like pins. If one of the pins are missing you need to drill a hole and pin back the original pin or make it more stronger. you can put a paper clip at a angle drilled and that will hold you hand.
Theres only 2 parts. Socket which is the hand. Double Ball joint which is attached to the body. It is normal that the socket is enclosed in the hand.
If you want it to look like the other side. You will need to move the socket up towards by pulling on the elastic plastic in the hand downward...
I tried that last night. Grinded the lip of the joint and masking sol inside the joint. Works perfect. The ball snapped in and the joint is tight. You were totally right on this grinding. You need to grind the lip for sure to put the joint in.
Masking sol .
https://www.hlj.com/product/MDLS106
You need to apply it on the joint , A THin layer. The layer will dry and become plastic like. Make sure you put some on the other side of the joint. You need to push the joint while its wet becasue that will allow it to spread. Make sure none...
You don't want to grind the joint in the leg. The material in the hot toys joints are far superior then any joints I have seen. They use a really hard plastic which once you connect the joint should be tight. You never grind a joint to try to fit the peg. What you doing is that you losing...
Don't spray tamiya clear gloss over this figure. The gloss is only used for plastics and hard materials not soft rubbery materials. Your hot toys aliens is going to have clear cracks. Also , tamiya uses has two different clears. Acrylic and enamel. Stay clear from these products on any soft...