Ductapenguin
Freakalicious
- Joined
- Jun 17, 2016
- Messages
- 28
- Reaction score
- 0
Hey,
I'm fairly new to this hobby and have a bit of a question (wasn't sure where to post, sorry if this is the wrong place)
I've got a 1/4 in statue (Kitana from Mortal Kombat) and I'm having some issues getting her to sit flush in the base. The back peg on her right foot doesn't quite get to the bottom, and as a result there isn't much weight on the front 'cup' underneath her shoe.
I've attached a picture of the statue for reference, but it's a bit difficult to capture what I am talking about...
It's been sitting undisturbed for several months without issue, but I'm paranoid that it might snap over time. It's really only a 1-2 cm's up from being flat in the base, and I'm hesitant to touch it for fear of breaking something.
Any insight would be greatly appreciated.
I'm fairly new to this hobby and have a bit of a question (wasn't sure where to post, sorry if this is the wrong place)
I've got a 1/4 in statue (Kitana from Mortal Kombat) and I'm having some issues getting her to sit flush in the base. The back peg on her right foot doesn't quite get to the bottom, and as a result there isn't much weight on the front 'cup' underneath her shoe.
I've attached a picture of the statue for reference, but it's a bit difficult to capture what I am talking about...
It's been sitting undisturbed for several months without issue, but I'm paranoid that it might snap over time. It's really only a 1-2 cm's up from being flat in the base, and I'm hesitant to touch it for fear of breaking something.
Any insight would be greatly appreciated.